Lorax 6th Birthday Party

To celebrate her daughter’s sixth birthday, Rebecca, also known as the Left Coast Mama, created this whimsical and colorful Lorax themed party featuring many DIY touches. You can see the full post of images here, but below are the mustachioed highlights. Take note of the chocolate Lorax ‘staches on sticks!

Lovely! The only thing this party was missing is a photo booth and the Lorax Mustache on a Stick photo prop by Whisker Works. Of course, those chocolate ‘staches on sticks came pretty darn close!

Share your ‘stache bash! Click on the “Submit Photos” link above.

Kid-sized photo booth!

This kid-sized photo booth is ideal for a little one’s birthday party! It’s also easily customizable by using theme-appropriate paper to match your party.

Total cost: $10
Total time: 1 hour

Materials
– Project display board
– Wrapping paper
– 8×10″ frame
– Spray paint
– Glue gun

I was able to find the display board (for science fair projects) and frame at my local dollar store. I bought the heavy-weight wrapping paper and white Krylon Short Cuts spray paint from a craft store.

Instructions

1. Remove the glass and backing from the frame so you are left with just the 8×10″ decorative frame. In a well-ventilated area (I recommend the outdoors!), coat the frame with the can of spray paint.


2. After the paint has dried (approximately 30 minutes), position the frame on the project display board where you would like it. Then trace around the frame, marking the board. Using a scissors, blade or box cutter, remove the rectangular box that you just marked.
3. Unroll the wrapping paper and cut to size, allowing at least one inch of excess all around the board. Fold the paper around the board and tape into place. Be sure to use a lot of tape around the creases.
4. Through the hole cut in the board, trim the paper, allowing approximately one inch of excess. Wrap the paper through the hole and tape securely into place. You’ll want to use a lot of tape around this area, as it will get the most use.


5. Fit your frame into position within the hole and allow about 1/8″ to stick through the back. Then use your glue gun and glue around the edges of the frame, mounting it to the board.

You’re all done! Just place the photo booth where the kids can reach it. After the party, just fold it up and tuck it away – it takes up very little space!

Additional ideas:
– For extra strength, use fabric instead of wrapping paper. You’ll want to use a spray adhesive for the fabric, instead of tape.
– To accommodate bigger kids, use a larger frame. But just keep in mind that you’ll be limited to the size of the project display board.

Much thanks to Susan from Rivers Photography for helping with the kiddo portraits. Green mustache prop by Whisker Works.